Installing Wide Draper Deflectors - MacDon D65 Operator's Manual

7. Open the endshield. For instructions, refer to
8. Loosen nuts (A) on the cutterbar until retainer (B) is loose.
9. Remove fasteners securing the deflector to the endsheet.
Nuts (A) are accessible from the side of the endshield, and
nuts (B) on the uppermost fasteners are accessible from
behind deflector (C).
10. Remove deflector (C).
11. Remove bolts (A) and (D), and remove deflector
support (B).
12. Reinstall bolt (D) (if not reinstalling support [B]) to secure
belt guide (C) to the opposite side of the endsheet.
Otherwise, position support (B) as shown, and secure it
with bolt (D).
13. Repeat this procedure at the opposite end of the header.

Installing Wide Draper Deflectors

DANGER
To prevent bodily injury or death from the unexpected start-up of the machine, always stop the engine and remove the
key from the ignition before making adjustments to the machine.
214327
MAINTENANCE AND SERVICING
Opening Endshield, page
Figure 5.142: Deflector Retainer
Figure 5.143: Wide Deflector
Figure 5.144: Deflector Support
197
35.
A
B
B
C
C
A
D
B
A
Revision B