Removing Crop Dividers From Header Without Latch Option; Installing Crop Dividers On Header With Latch Option - MacDon D65 Operator's Manual

Removing Crop Dividers from Header without Latch Option

To remove crop dividers from a header without the latch option, follow these steps.
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason. Refer to the windrower
operator's manual for instructions regarding the proper use and storage of header safety props.
1. Lower reel, raise header, stop engine, remove key, and engage safety props. For instructions, refer to your
windrower operator's manual.
2. Open/remove header endshields. Refer to
3. Remove bolt (A), lock washer and flat washer.
4. Lower divider (B) and lift off endsheet.
5. Close/replace header endshields.
Endshields, page 37.

Installing Crop Dividers on Header with Latch Option

To install crop dividers on a header with the latch option, follow these steps.
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason. Refer to the windrower
operator's manual for instructions regarding the proper use and storage of header safety props.
1. Lower reel, raise header, stop engine, remove key, and engage safety props. For instructions, refer to your
windrower operator's manual.
2. Open header and remove endshields.
169899
OPERATION
4.2.3 Endshields, page
Refer to 4.2.3
Figure 4.50: Crop Divider
69
37.
Revision A