Installing Endless Draper - MacDon D65 Operator's Manual

7. Insert a pry bar (A) into the hole located in the deck
at the approximate deck mid-point location, and lift the
deck clear of the cutterbar.
NOTE:
Ensure pry bar is long enough to accommodate
the width of the draper.
8. Support pry bar (A) on a suitably sized stand (B).
9. Pull draper off deck and onto pry bar.
10. Remove stand (B), draper, and pry bar (A).

5.7.5 Installing Endless Draper

DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason.
1. Insert a pry bar (A) through draper and locate bar
in hole in deck located at approximately the deck
mid-point.
NOTE:
Pry bar should be sufficient length to
accommodate width of draper.
2. Lift deck clear of cutterbar and support bar on a suitably
sized stand (B).
3. Slide draper onto deck.
147725
MAINTENANCE AND SERVICING
Figure 5.101: Lifting the Deck
Figure 5.102: Removing Draper
Figure 5.103: Supporting the Draper
169
Revision A