MAINTENANCE AND SERVICING
6.4 Electrical
Use electrical tape and wire clips as required to prevent wires from dragging or rubbing.
Keep lights clean and replace defective bulbs.
6.4.1 Replacing Light Bulbs
To replace a light bulb, follow these steps:
1. Using a Phillips screwdriver, remove screws (A) from
fixture and remove plastic lens.
2. Replace bulb and reinstall plastic lens and screws.
NOTE:
Use bulb trade #1156 for amber clearance lights and
#1157 for red tail light (Slow Speed Transport option).
Figure 6.27: Clearance Light
139
169899
Revision A