Converting From Field To Transport Position; Moving Front (Left) Wheels Into Transport Position - MacDon D65 Operator's Manual

9. Pull pin (A) at
counterclockwise to position shown and lock with
pin (A).
10. Remove hairpin (B) from latch (C).
11. Lift wheel, lift latch (C), and engage lug (D) onto left
axle. Ensure latch closes.
12. Secure latch with hairpin (B), with open end of pin
facing rear of combine.
NOTE:
Installing hairpin with the open end facing the
cutterbar will cause it to be dislodged by crop
during operation.
IMPORTANT:
Check that wheels are locked and that handle is in locked
position.
13. The conversion is complete when the wheels are as
shown.

4.15.4 Converting from Field to Transport Position

To convert the header from field to transport position, follow these steps.
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason. Refer to the windrower
operator's manual for instructions regarding the proper use and storage of header safety props.

Moving Front (Left) Wheels into Transport Position

To move the left transport wheels into transport position,
follow these steps:
169899
OPERATION
right wheel, swivel wheel
Figure 4.83: Rear Axles
Figure 4.84: Field Position
A - Left Side
96
B - Right Side
Revision A