MacDon D65 Operator's Manual page 73

Reposition left arm cylinder as follows:
NOTE:
Reel components are not shown for clarity.
6. Remove pin (A) securing cylinder (B) to bracket/light
assembly (C).
7. Remove bolts (D) securing bracket (C) to reel arm and
remove bracket/light assembly.
8. If necessary, remove cable tie securing harness to
bracket or reel arm.
9. Swivel light to working position as shown.
10. Reposition bracket/light assembly (C) on reel arm as
shown and reinstall the four bolts (D) to secure bracket
to reel arm. Tighten bolts.
11. Push reel back and reinstall cylinder (B) to bracket with
pin (A). Secure pin with cotter pin.
12. Secure light harness to bracket with plastic tie wrap.
13. Check reel clearance to backsheet, upper cross auger
(if installed) and reel braces.
14. Adjust reel tine pitch (if required).
procedures, refer to
169899
For adjustment
4.7.10 Reel Tine Pitch, page
OPERATION
Figure 4.34: Forward Position
65.
Figure 4.35: Rearward Position
61
Revision A