MacDon D65 Operator's Manual page 227

10. At the cam end, install endshield support (A) at
applicable tine tube location on the cam end.
11. Re-install reel endshields.
Endshields, page 218.
Center Disc and Tail End Bushings
12. Position bushing halves (B) on tine tube with flangeless
end adjacent to reel arm, and locate lug in each
bushing half in hole in tine tube.
13. Slide reel arm (A) onto bushing (B) and position against
disc at original location.
14. Reinstall any fingers or tines that were removed.
Refer to:
• Installing Steel Tines, page 205
• Installing Plastic Fingers, page 207
15. Install bushing clamp (A) onto tine tube adjacent to
flangeless end of bushing (B).
16. Position clamp (A) on bushings (B) so that edges
of clamp and bushing are flush when clamp fits into
groove on bushing and lock tabs are engaged.
169899
MAINTENANCE AND SERVICING
Refer to 6.8.6 Reel
215
Figure 6.189: Cam End
Figure 6.190: Tail End
Figure 6.191: Bushing
Revision A