Removing Reel Drive Motor - MacDon D65 Operator's Manual

Removing Reel Drive Motor

To remove the reel drive motor from a single or double reel header, follow these steps:
1. Disconnect hydraulic lines (A) at motor (B). Cap or plug
open ports and lines.
2. Slide motor (B) and motor mount (C) up or down so that
attachment bolts (D) are exposed in holes and slots in
back plate.
3. Remove four nuts (A) and attachment bolts and
remove motor (B) from motor mount (C). Retrieve the
spacer (if installed) from between the motor (B) and
motor mount (C).
169899
MAINTENANCE AND SERVICING
Figure 6.229: Reel Drive Motor
Figure 6.230: Reel Drive Motor
230
Revision A