Timed Double Knife Drive Belts - MacDon D65 Operator's Manual

4. Ensure that clearance between belt (A) and belt
guide (B) is 1/32 in. (1 mm).
5. Loosen three bolts (C), and adjust position of guide (B)
as required.
6. Tighten bolts (C).
7. Close endshield. Refer to
38.
NOTE:
Readjust tension of a new belt after a short run-in period
(about five hours).

Timed Double Knife Drive Belts

This section applies to 35-foot and smaller double knife model D65 Draper Headers with timed drives.
Removing Timed Drive V-Belts
1. Open left endshield. Refer to
page 37.
2. Loosen two bolts (A) on endsheet.
3. Turn adjuster bolt (B) to loosen the two V-belts (C) and
remove them.
169899
MAINTENANCE AND SERVICING
Closing Endshields, page
Opening Endshields,
164
Figure 6.75: Knife Drive
Figure 6.76: Knife Drive V-Belts
Revision A