MacDon D65 Operator's Manual page 228

17. Tighten clamp (A) with modified channel lock pliers (B)
so that finger pressure will NOT move clamp.
IMPORTANT:
Over-tightening clamp may result in breakage.
18. At the center disc, install the bolts (A) securing arm (B)
to disc.
19. At the tail end, install reel arm (B) and endshield
support (C) at applicable tine tube location with bolts
(A). Re-install endshields.
NOTE:
There are no endshields on the center discs.
169899
MAINTENANCE AND SERVICING
Figure 6.192: Clamp Tool
Figure 6.193: Tail End
216
Revision A