Tightening Drive Chain; Installing Drive Cover - MacDon D65 Operator's Manual

Tightening Drive Chain

1. Ensure the six bolts (B) securing motor mount to chain
case are loose.
2. Slide motor and motor mount upwards until chain (A)
is tight, and tighten bolts (nuts on backside).
3. There should be 1/8 in. (3 mm) of slack in the chain.
Adjust if necessary.
4. Torque bolts (B) to 54 lbf·ft (73 N·m).

Installing Drive Cover

Install reel drive cover as follows:
1. For SINGLE REEL DRIVE, position reel drive cover (A)
to the reel drive and secure with four bolts (B).
2. For DOUBLE REEL DRIVE, position the lower cover
(C) first (if removed) and secure with three bolts (D).
Install upper cover (A) using the six bolts (B).
169899
MAINTENANCE AND SERVICING
Figure 6.258: Reel Drive
Figure 6.259: Single Reel Drive Cover
Figure 6.260: Double Reel Drive Cover
241
Revision A