Replacing Draper Deflectors; Removing Wide Draper Deflectors - MacDon D65 Operator's Manual

7. Tension the draper, with tensioner bolt (A) and follow
the directions on the decal for proper draper tensioning.
8. Disengage the reel and header safety props.
9. Start the engine and lower header and reel.
10. Run machine to verify that draper tracks correctly.
11. If adjustment is required, refer to
Header Draper Tracking, page
6.7.9 Replacing Draper Deflectors
Removing Wide Draper Deflectors
To remove draper deflector, follow these steps: Left end removal is illustrated.
1. Raise reel fully and lower header to ground.
2. Shift decks to allow work space at one end of header if hydraulic deck shift installed, otherwise move decks
manually after shutting down windrower.
3. Stop engine, remove key, and engage reel safety props.
4. Open endshield.
5. Loosen nuts (A) on cutterbar until retainer (B) is loose.
169899
MAINTENANCE AND SERVICING
6.7.6 Adjusting
184.
195
Figure 6.141: Draper Tensioner
Figure 6.142: Deflector Retainer
Revision A