Storing Tow-Bar - MacDon D65 Operator's Manual

5. Remove clevis pin
later installation.
6. Push latch (B) and lift tow-bar (C) from hook.
Release latch.
7. Reinstall clevis pin.

Storing Tow-Bar

Store tow-bar as follows:
1. At the left end of the header, place the inner end
of the outer half of the tow-bar in cradle (A) on
header backtube.
2. For clevis or pintle end of tow-bar, secure in support (B)
on endsheet with hitch pin (C). Secure with lynch pin.
3. Install rubber strap (D) on cradle (A).
169899
OPERATION
(A) and set aside for
Figure 4.73: Tow-Bar Latch
Figure 4.74: Tow-Bar Storage
91
Revision A