MacDon D65 Operator's Manual page 109

CAUTION
Stand clear of wheels and release linkage carefully as
wheels will drop once the mechanism is released.
1. Pull handle (B) up to release and raise the linkage (A)
fully upward in the vertical support.
2. Raise header fully, stop engine, and remove key from
ignition. Engage header safety props.
3. Remove hair pin and clevis pin (A).
4. Pull latch handle (B) to release suspension linkage (C)
and pull suspension linkage (C) away from spindle (D).
5. Slowly lower the wheels.
6. Lower handle (B) to lock.
169899
OPERATION
Figure 4.85: Raising Linkage
Figure 4.86: Lowering Wheels
Figure 4.87: Locking Linkage
97
Revision A