MacDon D65 Operator's Manual page 223

Tine Tube Support Bushings (If installed)
If the tine tube reinforcing kit is installed:
13. Locate the support (A) that requires a new bushing.
14. Remove four bolts (B) securing channels (C) to support
(A).
15. If finger (D) is too close to support to allow access
to bushing, remove screw (E) and remove finger (D).
Refer to Removing Plastic Fingers, page
16. Release bushing clamp (A) using a small screwdriver
to separate the serrations.
bushing.
169899
MAINTENANCE AND SERVICING
206.
Move clamp clear of
211
Figure 6.178: Tine Tube Support
Figure 6.179: Bushing Clamp
Figure 6.180: Bushing Clamp
Revision A