MacDon D65 Operator's Manual page 66

Adjusting Inner Skid Shoe
1. Fully raise the stabilizer wheels or slow speed transport wheels (if installed). Refer to:
• Adjusting Stabilizer Wheels, page
• Adjusting Stabilizer/Slow Speed Transport Wheels, page 50
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason. Refer to the windrower
operator's manual for instructions regarding the proper use and storage of header safety props.
2. Fully raise header, engage safety props, shut off engine, and remove key.
3. Remove lynch pin (A).
4. Hold shoe (B) and remove pin (C) by pulling down to
disengage frame and then pulling away from shoe.
5. Raise or lower skid shoe (B) to desired position using
holes in support (D) as a guide.
6. Reinsert pin (B), engage in frame, and secure with
lynch pin (A).
7. Check that all of the skid shoes are adjusted to the
same position.
8. Adjust header angle to desired working position using
the machine's header angle controls. If angle is not
critical, set it to mid-position.
9. Check header float as described in your windrower
operator's manual.
Adjusting Outer Skid Shoe
1. Fully raise the stabilizer wheels or slow speed transport wheels if installed. Refer to:
• Adjusting Stabilizer Wheels, page 52
• Adjusting Stabilizer/Slow Speed Transport Wheels, page 50
169899
OPERATION
52, or
Figure 4.26: Inner Skid Shoe
Figure 4.27: Inner Skid Shoe
or
54
Revision A