3. Turn bolt (A) counterclockwise to fully loosen draper.
White indicator bar (B) will move outboard in direction
of arrow to indicate that draper is loosening.
4. Push draper away from cutterbar (as shown) to expose
deck support (A).
NOTE:
There are two or three supports, depending on
header size.
5. Remove two center nuts (B) at each support.
6. Move deck away from cutterbar to disengage
deck supports.
169899
MAINTENANCE AND SERVICING
Figure 6.111: Draper Tensioner
Figure 6.112: Deck Support
181
Revision A