MacDon D65 Operator's Manual page 222

10. Remove bolt (A) at on cam linkage so that tine tube (B)
is free to rotate.
11. Release bushing clamps (A) at the cam discwith a
small screwdriver to separate the serrations. Move
clamps off bushings.
12. Slide tine tube (A) outboard to expose the bushing.
Remove the bushing halves (B). If required remove the
next tine or plastic finger, so that the arm can slide off
the bushing. Refer to:
• Removing Plastic Fingers, page 206
• Removing Steel Tines, page 205
169899
MAINTENANCE AND SERVICING
Figure 6.175: Cam End
Figure 6.176: Bushing Clamp
Figure 6.177: Cam End
210
Revision A