Replacing Support - MacDon D65 Operator's Manual

6. Move endshield (A) away from support (B), and place
new endshield (C) onto supports.
7. Reattach end of endshield (A) to support (B).
8. Reinstall bolts (D).
9. Tighten all hardware.

Replacing Support

1. Lower header and reel, and shut down engine. Remove key from ignition.
2. Manually rotate reel for access to endshield support (A)
to be replaced.
3. Remove bolt (B) from support (A).
4. Remove bolts (C) from support (A) and two
adjacent supports.
5. Move endshields (A) away from tine tube and rotate
support (B) towards reel to remove it.
6. Insert tabs of new support (B) into slots in endshields
and rotate into endshields.
both endshields.
7. Secure support (B) to disc with bolt (C) and nut. Do
not tighten.
8. Secure endshields (A) to support (B) with bolt (C) and
nut. Do not tighten.
9. Reattach supports with bolts (C) and nuts.
10. Check clearance between tine tube and endshield
support, and adjust if necessary.
11. Torque nuts to 20 ft·lbf (27 N·m).
169899
MAINTENANCE AND SERVICING
Ensure tabs engage
220
Figure 6.203: Endshields
Figure 6.204: Endshield Supports
Figure 6.205: Endshield Supports
Revision A