MacDon D65 Operator's Manual page 42

Guard: Pointed / Forged / Double Heat Treated (DHT)
Hold-Down: Sheet Metal / Adjustment bolt
Guard: Pointed / Forged / Case Hardened (CH)
Hold-Down: Sheet Metal / Adjustment Bolt
Guard: Stub / Forged Bottom / Forged Top / Adjustment Plate
Guard: Stub / Forged Bottom / Sheet Metal Top / Adjustment Bolt
Guard: 4 Point / No-choke Design (2 Long Points with Tangs / 2 Short Points without Tangs)
Guard Angle (cutterbar on ground)
Center-Link Retracted
Center-Link Retracted
Center-Link Extended
Center-Link Extended
CONVEYOR (Draper) and DECKS
Draper Width
Draper Drive
Draper Speed
Delivery Opening Width (Center Delivery) / Variable by
Shifting Decks
Delivery Opening Height (under Frame Tube at 8 in.
Cutting Height )
PR15 PICK-UP REEL
Quantity of Tine Tubes
Center Tube Diameter
Finger Tip Radius
Effective Reel Diameter (Via Cam Profile)
Finger Length
Finger Spacing (Staggered on Alternate Bats)
Reel Drive
Reel Speed (Auto-Adjust from Cab Using Ground Speed Index)
FRAME and STRUCTURE
169899
SPECIFICATIONS
15–25 ft.
30–40 ft.
15–25 ft.
30–40 ft.
15 ft.
20, 25, 30,
35, 40 ft.
Center-Link
Fully
Retracted
Center-Link
Fully
Extended
15 to 30 ft.
35 ft.
Factory Set
Adjustment Range
30
7.5 Degrees
2.5 Degrees
17.0 Degrees
12.0 Degrees
41-5/8 in. (1057 mm)
Hydraulic
0–742 fpm (225 m/min.)
60-5/8 – 69-11/16 in.
(1540–1770 mm)
67-1/8 – 76-11/16 in.
(1720–1950 mm)
37-5/8 in. (955 mm)
43-1/2 in. (1105 mm)
5, 6, or 9
8 in. (203 mm)
10 in. (254 mm)
31-1/2 in. (800 mm)
30-3/16 – 31-1/2 in.
(766–800 mm)
65 in. (1650 mm)
11 in. (290 mm)
6 in. (150 mm)
Hydraulic
0–85 rpm
D65
O
F
O
F
O
F
O
F
O
F
S
S
S
S
S
S
S
S
S
S
S
S
S
Revision A