Removing Drive Cover; Loosening Drive Chain; Disconnecting The Reel Drive Method - MacDon D65 Operator's Manual

Removing Drive Cover

1. Remove the six bolts (B) that secure the upper cover
(A) to the reel drive and to the lower cover (C).
NOTE:
The lower cover (C) may also be removed by
taking off the three bolts (D).

Loosening Drive Chain

1. Loosen nuts (A). Slide motor (B) and motor mount (C)
down towards reel shaft.

Disconnecting the Reel Drive Method

1. Support inboard end of right reel with a front end loader
and nylon slings (or equivalent setup).
NOTE:
To avoid damaging or denting center tube, support reel
as close as possible to the end disc.
169899
MAINTENANCE AND SERVICING
Figure 6.238: Double Reel
Figure 6.239: Reel Drive
Figure 6.240: Supporting Reel
234
Revision A