MacDon D65 Operator's Manual page 199

5. Set deck (A) to 5/16–3/8 in.
cutterbar (C) to create a seal.
6. Tighten deck support hardware (D).
7. Check dimension (B) again it should be set to
5/16–3/8 in. (8–9 mm).
8. Tension draper. Refer to
Tension, page 178.
9. Adjust the backsheet deflector (A). Loosen nut (D)
and adjust deflector (A) until there is a 0.04–0.3 in.
(1–7 mm) gap (C) between the draper (B) and the
deflector (A).
169899
MAINTENANCE AND SERVICING
(8–9 mm) below the
6.7.3 Adjusting Draper
187
Figure 6.123: Deck Support
Figure 6.124: Backsheet Deflector
Revision A