Chapter 5 Function Code Table; Standard Function Parameters - IACDRIVE I5300 Series User Manual

Function Code Table

Chapter 5 Function Code Table

If PP-00 is set to a non-zero number, parameter protection is enabled. You must enter the
correct user password to enter the menu.
To cancel the password protection function, enter with password and set PP-00 to 0.
Group P and Group A are standard function parameters. Group U includes the monitoring
function parameters.
The symbols in the function code table are described as follows:
"☆": The parameter can be modified when the AC drive is in either stop or running state.
"★": The parameter cannot be modified when the AC drive is in the running state.
"●": The parameter is the actually measured value and cannot be modified.
"*": The parameter is factory parameter and can be set only by the manufacturer.

5.1 Standard Function Parameters

Function
Parameter Name
Code
P0-00 G/P type display
P0-01 Motor 1 control mode
P0-02 Command source selection
Main frequency source X
P0-03
selection
Group P0: Standard Function Parameters
1: G type (constant torque load)
2: P type (variable torque load
e.g. fan and pump)
0: Sensorless flux vector control
(SFVC)
1: Closed-loop vector control
(CLVC)
2: Voltage/Frequency (V/F)
control
0: Operation panel control (LED off)
1: Terminal control (LED on)
2: Communication control (LED
blinking)
0: Digital setting (non-retentive at
power failure)
1: Digital setting (retentive at
power failure)
2: AI1
3: AI2
4: AI3
- 80 -
Setting Range
I5300 User Manual
Default Property
Model
●
dependent
0
★
0
☆
0
★