IACDRIVE I5300 Series User Manual page 213

I5300 User Manual
The swing amplitude is set in PB-00 and PB-01. When PB-01 is set to 0, the swing amplitude
is 0 and the swing frequency does not take effect.
Figure 6-30 Swing frequency control
Output
frequency (Hz)
Swing frequency
upper limit
Set frequency Fset
Swing frequency
lower limit
RUN
command
Function Code
Swing frequency
PB-00
setting mode
This parameter is used to select the base value of the swing amplitude.
• 0: Relative to the central frequency (P0-07 frequency source selection)
It is variable swing amplitude system. The swing amplitude varies with the central
frequency (set frequency).
• 1: Relative to the maximum frequency (P0-10 maximum output frequency)
It is fixed swing amplitude system. The swing amplitude is fixed.
Function Code
PB-01
PB-02
This parameter is used to determine the swing amplitude and jump frequency amplitude.
The swing frequency is limited by the frequency upper limit and frequency lower limit.
• If relative to the central frequency (PB-00 = 0), the actual swing amplitude AW is the
calculation result of P0-07 (Frequency source selection) multiplied by PB-01.
• If relative to the maximum frequency (PB-00 = 1), the actual swing amplitude AW is the
calculation result of P0-10 (Maximum frequency) multiplied by PB-01.
Jump frequency = Swing amplitude AW x PB-02 (Jump frequency amplitude).
• If relative to the central frequency (PB-00 = 0), the jump frequency is a variable value.
• If relative to the maximum frequency (PB-00 = 1), the jump frequency is a fxed value.
The swing frequency is limited by the frequency upper limit and frequency lower limit.
+Aw
-Aw
Textile kick frequency
= Aw x PB-02
Accelerate by
acceleration time
Parameter Name
Parameter Name
Swing frequency amplitude
Jump frequency amplitude
Swing amplitude
Aw = Fset x PB-01
Swing
Triangular
cycle
rising time
Setting Range
0: Relative to the central frequency
1: Relative to the maximum frequency
Setting Range
0.0%–100.0%
0.0%–50.0%
- 213 -
Description of Function Codes
Time (t)
Decelerate by
deceleration time
Default
0
Default
0.0%
0.0%