Viewing And Modifying Function Codes - IACDRIVE I5300 Series User Manual

Operation, Display and Application Examples
Key Name
STOP
Stop/Reset
RES
Multifunction
MF.K
Menu mode
QUICK
selection

4.2 Viewing and Modifying Function Codes

The operation panel of the I5300 adopts three-level menu.
The three-level menu consists of function code group (Level I), function code (Level II), and
function code setting value (level III), as shown in the following figure.
Figure 4-2 Operation procedure on the operation panel
Status parameter
(default display )
50.00
PRG
You can return to Level II menu from Level III menu by pressing
• After you press
back to Level II menu and shifts to the next function code.
• After you press
returns to Level II menu and remains at the current function code.
Here is an example of changing the value of P3-02 to 15.00 Hz.
Figure 4-3 Example of changing the parameter value
50.00
PRG
P3
Stop the AC drive when it is in the running state and perform the
reset operation when it is in the fault state. The functions of this
key are restricted in P7-02.
Perform function switchover (such as quick switchover of
command source or direction) according to the setting of P7-01.
Perform switchover between menu modes according to the
setting of PP-03.
Level-I menu
(Select the function
code group)
P0
Level-II menu
PRG
(Select the
function code)
Level-III menu
(Set the value of
Not to save
the function code )
, the system saves the parameter setting first, and then goes
ENTER
, the system does not save the parameter setting, but directly
PRG
PRG
P0
PRG ENTER
P3-03
Function
If there is a blinking digit , press
/ /
ENTER
P0-03
ENTER
5
PRG
the setting
ENTER
P3 P3-00
015.00 010.00
- 48 -
I5300 User Manual
to modify the digit .
PRG
P0 - 04
ENTER
Next function
code
ENTER
To save
the setting
or .
PRG
ENTER
P3-02
ENTER
010.00