IACDRIVE I5300 Series User Manual page 51

I5300 User Manual
PP-03 is used to determine whether the user-defned group and user-modifed group are
displayed.
Function Code Parameter Name
Individualized
PP-03 parameter display
property
-bASE
It indicates all function codes of the I5300. After the mode is switched over to
level I menu is displayed.
-USEr
The user-defined menu is set to facilitate viewing and modifying of commonly used function
codes. In this mode, the display parameter uP3.02 indicates function code P3-02. You can
also modify parameters in this mode as in common editing state. After the mode is switched
-USEr
over to , level II menu is displayed.
The user-defned parameters are included in group PE. If PE is set to P0.00, it indicates that
no function codes are available. A maximum of 30 parameters can be included in group PE.
If "NULL" is displayed, it indicates that the user-defined menu is null.
A total of 16 parameters are pre-stored in the user-defined menu, as listed in the following
table.
P0-01 Motor 1 control mode
P0-02 Command source selection
P0-03 Main frequency source X selection
P0-07 Frequency source selection
P0-08 Preset frequency
P0-17 Acceleration time 1
P0-18 Deceleration time 1
P3-00 V/F curve setting
You can edit the user-defined menu based on actual requirements.
--C--
In you modified menu, only the parameters that are modified to a non-default value are
displayed. The menu is generated by the AC drive automatically. After the mode is switched
--C--
over to
Operation, Display and Application Example
Setting Range
-USEr
Unit's digit:
0: Not display
1: Display
--C--
Ten's digit:
0: Not display
1: Display
P3-01
P4-00
P4-01
P4-02
P5-04
P5-07
P6-00
P6-10
- 51 -
group display selection
group display selection
Torque boost
DI1 function selection
DI2 function selection
DI3 function selection
DO1 function
AO1 function selection
Start mode
Stop mode
Default
11
-bASE
,