IACDRIVE I5300 Series User Manual page 165

I5300 User Manual
If the frequency source is multi-reference, the value 100% of PC-00 to PC-15 corresponds to
the value of P0-10 (Maximum frequency).
Besides the multi-speed function, the multi-reference can be also used as the PID setting
source or the voltage source for V/F separation, satisfying the requirement on switchover of
different setting values.
Two terminals for acceleration/deceleration time selection have four state combinations, as
listed in the following table.
Table 6-3 State combinations of two terminals for acceleration/deceleration time selection
Terminal 2 Terminal 1
OFF
OFF
ON
ON
Two motor selection terminals have four state combinations, corresponding to four motors,
as listed in the following table.
Table 6-4 State combinations of two motor selection terminals
Terminal 2
OFF
OFF
ON
ON
Function Code
P4-10
It is used to set the software filter time of DI terminal status. If DI terminals are liable to
interference and may cause malfunction, increase the value of this parameter to enhance
the anti-interference capability. However, increase of DI filter time will reduce the response
of DI terminals.
Function Code
P4-11 Terminal command mode
This parameter is used to set the mode in which the AC drive is controlled by external
terminals. The following uses DI1, DI2 and DI3 among DI1 to DI10 as an example, with
allocating functions of DI1, DI2 and DI3 by setting P4-00 to P4-02.
Acceleration/Deceleration Time
OFF Acceleration/Deceleration time 1
ON Acceleration/Deceleration time 2
OFF Acceleration/Deceleration time 3
ON Acceleration/Deceleration time 4
Terminal 1 Selected Motor
OFF
ON
OFF
ON
Parameter Name
DI filter time
Parameter Name
Description of Function Codes
Selection
Corresponding Parameters
Motor 1 Group P1, Group P2
Motor 2
Motor 3
Motor 4
Setting Range
0.000–1.000s
Setting Range
0: Two-line mode 1
1: Two-line mode 2
2: Three-line mode 1
3: Three-line mode 2
- 165 -
Corresponding
Parameters
P0-17, P0-18
P8-03, P8-04
P8-05, P8-06
P8-07, P8-08
Group A2
Group A3
Group A4
Default
0.010s
Default
0