IACDRIVE I5300 Series User Manual page 3

I5300 User Manual
Function
Multi-motor switchover
Restoring user parameters
Higher-accuracy AI/AO
Customized parameter
display
Modified parameter display
Operation selection at fault
occurrence
PID parameters switchover
PID feedback loss detection
DI/DO positive or negative
logic
DI/DO response delay
Power dip ride through
Timing operation
User programmable function
Load allocation
Four motors can be switched over via four groups of
motor parameters.
It allows you to save or restore the parameters set by
yourself.
The AI/AO accuracy can reach almost 20 mv via factory
correction or on-site correction.
You can customize the parameters that need to be
displayed.
You can view the modified parameters.
You can select the reaction of the AC drive to a fault
occurring, based on the actual need. The reactions are as
below:
• Coast to stop
• Decelerate to stop
• Continue to run
You can also select the frequency at which the AC drive
continues to run.
Two groups of PID parameters can be switched over via
terminals or can be automatically switched over according
to deviation.
The PID feedback loss value can be set to realize PID
protection.
You can set the DI/DO positive or negative logic.
You can set DI/DO response delay time.
It ensures that the AC drive continues to run for a short
time when an instantaneous power failure or sudden
voltage reduction occurs.
The AC drive supports timing operation for 6500 minutes
at maximum.
The externally connected programmable card helps you
to realize secondary development.
Load allocation can be implemented between two I5300
series AC drives through point-to-point communication.
- 3 -
Description
Introduction