IACDRIVE I5300 Series User Manual page 58

Operation, Display and Application Examples
4.7.3 Stop Mode
The AC drive supports two stop modes, decelerate to stop and coast to stop, set in P6-10.
Figure 4-12 Diagram of two stop modes (decelerate to stop and coast to stop)
Frequency (f)
Running
P6-10 = 0: Decelerate to stop
frequency
P6-11 (Initial frequency of
stop DC braking)
Stop command
4.7.4 Timing Stop
The I5300 supports timing stop. This function is enabled by P8-42 and the timing duration
is determined by P8-43 and P8-44.
Figure 4-13 Setting of the timing stop function
Running state
P8-42 = 1 (timing function enabled )
P8-43 = 0 (timing duration determined by P8 - 44)
P8-44 (Timing duration )
Running
command
You can set the timing duration by means of analog input (such as potentiometer signal).
For details, see the description of P8-43.
P0-18
(Deceleration time)
P6-12 (Waiting
time of stop DC
braking)
P6-12 (Stop DC
No
braking time)
output
P6-13 (Stop DC
braking current, %)
Time (t)
Automatic stop
Frequency (f)
Running
frequency
Time (t)
Stop
command
Running state
P8-43 = 0 ( timing duration determined by P8-44)
Set P8-42 to 1 to enable the timing function .
Running
command
- 58 -
I5300 User Manual
P6-10 = 1: Coast to stop
Rotational speed under
load , coast to stop by
inertia
P8-44 (Timing duration )
Automatic stop
Time (t)
Time (t)