IACDRIVE I5300 Series User Manual page 140

Description of Function Codes
Function Code Parameter Name
Auxiliary
P0-04 frequency source
Y selection
When used as an independent frequency input channel (frequency source switched
over from X to Y), the auxiliary frequency source Y is used in the same way as the main
frequency source X (refer to P0-03).
When the auxiliary frequency source is used for operation (frequency source is "X and Y
operation"), pay attention to the following aspects:
1) If the auxiliary frequency source Y is digital setting, the preset frequency (P0-08) does
not take effect. You can directly adjust the set main frequency by pressing keys
and on the operation panel (or using the UP/DOWN function of input terminals).
2) If the auxiliary frequency source is analog input (AI1, AI2 and AI3) or pulse setting,
100% of the input corresponds to the range of the auxiliary frequency Y (set in P0-05
and P0-06).
3) If the auxiliary frequency source is pulse setting, it is similar to analog input.
The main frequency source X and auxiliary frequency source Y must not use the same channel.
That is, P0-03 and P0-04 cannot be set to the same value.
Function Code
Range of auxiliary frequency
P0-05
Y for X and Y operation
Range of auxiliary frequency
P0-06
Y for X and Y operation
If X and Y operation is used, P0-05 and P0-06 are used to set the adjustment range of the
auxiliary frequency source.
You can set the auxiliary frequency to be relative to either maximum frequency or main
frequency X. If relative to main frequency X, the setting range of the auxiliary frequency Y
varies according to the main frequency X.
0: Digital setting (non-retentive at power
failure)
1: Digital setting (retentive at power failure)
2: AI1
3: AI2
4: AI3
5: Pulse setting (DI5)
6: Multi-reference
7: Simple PLC
8: PID
9: Communication setting
Parameter Name
Setting Range
Note
Setting Range
0: Relative to maximum
frequency
1: Relative to main frequency X
0%–150%
- 140 -
I5300 User Manual
Default
0
Default
0
0