IACDRIVE I5300 Series User Manual page 244

Description of Function Codes
• If P0-22 (frequency reference resolution) is 1, the display range is -3200.0–3200.0 Hz.
• If P0-22 (frequency reference resolution) is 2, the display range is -320.00–320.00 Hz.
Function Code
U0-33
It displays the rotor position of the synchronous motor.
Function Code
U0-34
It displays the motor temperature obtained by means of AI3 sampling. For the motor
temperature detection, see F9-56.
Function Code
U0-35
It displays the current torque upper limit.
Function Code
U0-36
It displays the current resolver position.
Function Code
U0-37
It displays the current power factor angle.
Function Code
U0-38
It displays the phase A and B pulse counting of the current ABZ or UVW encoder. This value
is four times the number of pulses that the encoder runs. For example, if the display is 4000,
the actual number of pulses that the encoder runs is 4000/4 = 1000.
The value increase when the encoder rotates in forward direction and decreases when the
encoder rotates in reverse direction. After increasing to 65535, the value starts to increase
from 0 again. After decreasing to 0, the value starts to decrease from 65535 again.
You can check whether the installation of the encoder is normal by viewing U0-38.
Function Code
U0-39
U0-40
They display the target output voltage and current actual output voltage in the V/F
separation state. For V/F separation, see the descriptions of group P3.
Parameter Name
Synchronous motor rotor position
Parameter Name
Motor temperature
Parameter Name
Target torque
Parameter Name
Resolver position
Parameter Name
Power factor angle
Parameter Name
ABZ position
Parameter Name
Target voltage upon V/F separation
Output voltage upon V/F separation
0 V to rated motor voltage
0 V to rated motor voltage
- 244 -
I5300 User Manual
Display Range
0.0°–359.9°
Display Range
0–200 °C
Display Range
-200.0%–200.0%
Display Range
0–4095
Display Range
-
Display Range
0–65535
Display Range