IACDRIVE I5300 Series User Manual page 40

Mechanical and Electrical Installation
Type Terminal
AI1-GND
AI2-GND
DI1- OP
DI2- OP
DI3- OP
DI4- OP
DI6- OP
DI7- OP
DI5- O
P
AO1-GND
DO1-CME
FM- COM
T/A-T/B
T/A-T/C
J12
J3
J7
Name
Analog input 1
Analog input 2
Digital input 1
Digital input 2
Digital input 3
Digital input 4
Digital input 6
Digital input 7
Besides features of DI1–DI7, it can be used for high-speed
High-speed pulse
pulse input.
input
Analog output 1
Digital output 1
High-speed pulse
output
NC terminal
NO terminal
Extension card
interface
PG card interface
External operation
panel interface
Function Description
Input voltage range: 0–10 VDC
Impedance: 22 kΩ
Input range: 0–10 VDC/4–20 mA, decided by
jumper J8 on the control board
Impedance: 22 kΩ (voltage input), 500 Ω (current
input)
Optical coupling isolation, compatible with dual
polarity input
Impedance: 2.4 kΩ
Voltage range for level input: 9–30 V
Maximum input frequency: 100 kHz
Voltage or current output is decided by jumper J5.
Output voltage range: 0–10 V
Output current range: 0–20 mA
Optical coupling isolation, dual polarity open
collector output
Output voltage range: 0–24 V
Output current range: 0–50 mA
Note that CME and COM are internally insulated,
but they are shorted by jumper externally. In this
case DO1 is driven by +24 V by default. If you
want to drive DO1 by external power supply,
remove the jumper.
It is limited by F5-00 (FM terminal output mode
selection).
As high-speed pulse output, the maximum
frequency hits 100 kHz.
As open-collector output, its specification is the
same as that of DO1
Contact driving capacity:
250 VAC, 3 A, COSø = 0.4
30 VDC, 1 A
Applying to Overvoltage Category II circuit
I28-pin terminal
Connect to an optional card (I/O extension card,
PLC card and various bus cards)
Support various types of PG cards: OC,
differential, UVW and resolver.
Connect to external operation panel.
- 40 -
I5300 User Manual