Safety Cable; Clamp - High End Systems Studio Spot 250 User Manual

Spot 250 and Studio Color 250 fixture weights are listed in the section titled "Physical
Specifications" on page intro-4.

Safety Cable

High End Systems strongly recommends that you use safety cable when mounting any
fixture. You must supply your own safety cable and verify the cable is capable of
supporting the weight of the fixture. You can order galvanized safety cables from your
High End Systems dealer/distributor (see "Optional Accessories" on page intro-8).

Clamp

You must supply your own clamps and verify the clamp is capable of supporting the
weight of the fixture. You can order deluxe C-clamps for a two-inch truss from your
High End Systems dealer/distributor (see "Optional Accessories" on page intro-8).
Note: Due to the wide variety of possible lighting designs, High End Systems
cannot make specific mounting recommendations. Consider the
following procedure as a suggested guideline only.
Suggested mounting procedure:
1. Unplug the fixture. If the fixture has been operating, allow the fixture to cool
before handling.
2. Use two people to mount each fixture: one person to hold the fixture while it is
being secured in place, and one person to secure the fixture to its support and
attach safety cables.
Always stand on a firm, stable surface when mounting a fixture to its support. The
fixture should be at a height where you can comfortably work on it, and should
either be resting on a stable surface, or held in a stable manner. Do not allow one
person to both support and mount the fixture.
®
Studio Spot 250 / Studio Color
®
250 User Manual Setup and Installation
1
1-13