Setting The Fixture Voltage - High End Systems Studio Spot 250 User Manual

Note: Before sending anything to the factory, call your High End Systems
dealer/distributor for a Return Material Authorization (RMA) number.
The factory cannot accept any goods shipped without an RMA
number.

Setting the Fixture Voltage

Studio Spot 250 and Studio Color 250 fixtures are factory-set to 230V, 50Hz. If your
power source differs, you must change the fixture's input voltage to match your power
source. Studio Spot 250 and Studio Color 250 fixtures offer the following switch-
selectable input voltage/frequency settings:
• 100V, 50Hz
• 120V, 50 Hz
• 230V, 50 Hz
Warnings:
You will need:
• wide-tip, flat head screwdriver
• #1 Phillips-head screwdriver
To change the fixture's voltage/frequency setting:
1. Electrically isolate the fixture.
2. Using a wide-tip, flat head screwdriver, remove the two panel cover retaining
screws from each side of the fixture and remove the fixture's two panel covers (see
Figure 1-2).
1-2 Setup and Installation
1) Disconnect power before servicing.
2) This fixture must be serviced by qualified personnel.
The information in this section is intended to assist
qualified service personnel only.
3) Be sure to match the voltage selection jumper to your
power source prior to operating this equipment.
• 100V, 60 Hz
• 120V, 60 Hz
• 208V, 60 Hz
®
Studio Spot 250 / Studio Color
®
250 User Manual