Viewing Sensor Information (Sens); Resetting Fixture Hours (F/Rs) - High End Systems Studio Spot 250 User Manual

Viewing Sensor Information (SENS)

This menu option allows you to view whether a specified sensor if working correctly.
If you receive a "SENS ERR" error message on the LED display, this information may
help you determine where the problem originates (see "LED Display Error Messages"
on page 8-1).
Sensor information is available for the following:
• LTO - litho wheel*
• FX - effects wheel*
• LTR - litho (within the wheel)*
• COLR - color wheel*
• TILT - tilt
• PAN - pan
• CYAN - cyan wheel**
• BEAM - beam shaping (lenticular) wheel**
• YELW - yellow wheel**
• MAGN - magenta wheel**
*sensor information only available for Studio Spot 250 fixtures.
**sensor information only available for Studio Color 250 fixtures.
To view whether the specified sensor is working correctly:
1. Press and hold the <Menu> button until "ADDR" appears on the LED
display.
2. Using the <Up> and <Down> arrow buttons, scroll to the "INFO" menu
and press the <Enter> button to select the "INFO" menu.
3. Using the <Up> and <Down> arrow buttons, scroll to the "SENS" menu
and press the <Enter> button to select the "SENS" menu.
4. Using the <Up> and <Down> arrow buttons, scroll to the desired sensor
(listed above) and press the <Enter> button to select the desired option.
The LED will display "ON" if the sensor is obstructed (by a wheel tab), or
"OFF" if the sensor is not obstructed (by a pan or tilt notch).

Resetting Fixture Hours (F/RS)

This menu item allows you to track the number of hours the fixture has bee operating.
To reset the fixture hours to zero:
1. Press and hold the <Menu> button until "ADDR" appears on the LED
display.
4-38 Understanding the Menu System
®
Studio Spot 250 / Studio Color
®
250 User Manual