General Maintenance; Replacing Parts; Replacing Fuses - High End Systems Studio Spot 250 User Manual

Chapter 7

General Maintenance

This chapter includes information on replacing parts, installing optional accessories,
and cleaning your fixture. Please note the warnings under each heading before
servicing your fixture.
Warning: This fixture must be serviced by qualified personnel. The
information listed in this chapter is intended to assist qualified
personnel only.

Replacing Parts

Warnings: Disconnect power before servicing.
Replace fuses with the specified type and rating only.
Equipment surfaces may reach temperatures up to 130° C
(266° F). Allow the fixture to cool before handling.

Replacing Fuses

You will need:
• replacement fuse (see Table 7-1)
• wide tip, flat head screwdriver
• #1 Phillips-head screwdriver
To replace any of the three fuses located on the fixture's circuit board:
1. Electrically isolate the fixture. If the fixture has been operating, allow the
fixture to cool before handling.
®
Studio Spot 250 / Studio Color
®
250 User Manual General Maintenance
7
7-1