3. Tilt the fixture's head to access the lamp cap (see Figure 7-5).
Figure 7-5. Lamp cap and lamp assembly screws.
4. Using a wide tip, flat head screwdriver, loosen (but do not remove) the two
lamp assembly screws (see Figure 7-5).
5. Pull the lamp assembly straight out of the fixture (see Figure 7-6).
The lamp assembly is connected to the fixture by lamp socket wires (see Figure
7-6). Support the lamp assembly while replacing the lamp. Do not allow the
lamp socket wires to support the weight of the lamp assembly.
®
Studio Spot
250 / Studio Color
lamp
assembly
screws
lamp assembly
Figure 7-6. Remove the lamp assembly.
®
250 User Manual
lamp cap
General Maintenance
7
7-5