High End Systems Studio Spot 250 User Manual page 58

and Studio Color 250 fixtures on the link. The crossloading procedure is
explained in the section titled "Crossloading Fixture Software (XLD)" on page
4-28.
3. Upload the new software to all Studio Spot 250 or Studio Color 250 fixtures on
the link using the Status Cue lighting console.
Refer to the Status Cue User Manual for the procedure used to upload
software using a Status Cue lighting console.
Note: Remember that before you can upload new software, you must
disconnect any controllers, bypass any serial data distributors and/or
data line optoisolators, and bypass or make sure that any fixtures using
RS-422 communications (such as Dataflash
Intellabeam
the Studio Spot 250 or Studio Color 250 fixtures on the link. These
devices will block communication with any other Studio Spot 250 or
Studio Color 250 fixtures on the link.
Regardless of the method you chose to upload software, if you receive an error during
the upload, see "Upload and Crossload Troubleshooting" on page 8-9.
3-16 Operating the Fixture
®
fixtures, and Emulator
Studio Spot
®
AF1000 xenon strobes,
®
laser simulators) are located after
®
250 / Studio Color
®
250 User Manual