Figure 7-2. Loosen The Two Display Panel Retaining Screws; Figure 7-3. Lower The Display Panel; Figure 7-4. Fuses On The Circuit Board - High End Systems Studio Spot 250 User Manual

4. Using a Phillips-head screwdriver, loosen (but do not remove) the two display
panel retaining screws (see Figure 7-2).

Figure 7-2. Loosen the two display panel retaining screws.

5. Gently lower the display panel to access the
fuses on the circuit board (see Figure 7-3).
Support the display panel while replacing
the fuse. Do not allow the cables on the
circuit board to support the weight of the
display panel.
6. Locate the fuse to be replaced (see Figure
7-4).
Note: If you are replacing the F3 fuse, you
must first remove the protective
plastic covering over the fuse.
®
Studio Spot 250 / Studio Color

Figure 7-4. Fuses on the circuit board.

®
250 User Manual
LED display panel
retaining screw
Figure 7-3. Lower the display
panel.
F3
6.3A 250V FAST
F1
General Maintenance
gently lower the
display panel
7
F2
2.5A 250V FAST
F1
F2
7-3