Figure 7-7. Remove The Lamp From The Lamp Socket - High End Systems Studio Spot 250 User Manual

6. Holding the existing lamp by its ceramic base,
carefully pull the lamp straight out of the lamp
socket (see Figure 7-7).
Caution: Do not squeeze the lamp glass while
removing the existing lamp from the
socket. Lamp glass may shatter.
7. Remove all packaging materials from the new
lamp. Holding the new lamp by its ceramic base,
gently press the two base pins into the lamp
socket until the lamp is firmly seated.
Caution: When handling the new lamp, avoid contact with the lamp
glass. If the lamp glass is soiled by oil or dirt from skin, gloves,
etc., clean the cold lamp glass with an alcohol wipe. A soiled
lamp could overheat and burst, causing damage to the fixture.
8. Reinsert the lamp assembly straight into the fixture.
Make sure the lamp socket wires are not wrapped around the lamp and that
are not crimped while reinserting the lamp assembly.
9. Tighten the lamp assembly screws.
10. Reset the lamp hours to zero so that you can track the lamp life (see "Resetting
Lamp Hours (L/RS)" on page 4-39).
11. Optimize the new lamp (see "Optimizing the Lamp" on page 7-19).
7-6 General Maintenance
Figure 7-7. Remove the
lamp from the lamp socket.
®
Studio Spot 250 / Studio Color
®
250 User Manual