Figure 6-7. Lad™ Mounting/Alignment Screws - High End Systems Studio Spot 250 User Manual

9. Locate the three mounting/alignment screws on the laser aiming device
assembly (see Figure 6-7). These three screws can be used to adjust the
position of the laser beam.
10. Alignment screws 1 and 3 (shown in Figure 6-7) move the laser beam
horizontally, and screw 2 moves the laser beam vertically. Use the three
alignment screws to adjust the position of the laser so that it is positioned at the
ideal laser position of 3.3 in. (for Studio Spot 250 fixtures) or 3.5 in. (for Studio
Color 250 fixtures) directly above the center point of a perfectly round light
beam.
After you tighten/loosen each screw, release pressure from the screwdriver
before looking at the laser position on the wall. Applying pressure to the screw
can change the laser's position.
Note: If you have difficulty aligning the laser or turning the screws, loosen all
three screws and start over.
11. When the laser is aligned (or at a position you think will give you enough
accuracy for your needs) you are finished.
12. Turn the LAD off (see "Choosing a Macro (MACR)" on page 5-8, and choose
the "LROF" menu option).
13. Replace the bezel cover and engage the two bezel latches.
®
Studio Spot 250 / Studio Color
LAD screws
3
Figure 6-7. LAD™ mounting/alignment screws.
®
250 User Manual Laser Aiming Device (LAD™) Operation
2
1
6
6-7