Figure 6-6. Locate The Center Of The Beam On The Wall And Mark The Ideal Laser - High End Systems Studio Spot 250 User Manual

Extend the tape measure or ruler
1
through the vertical center of the beam.
Extend the tape measure or ruler
3
across the horizontal center of the
beam and lightly mark the center of
the beam on the wall along the ruler.
Figure 6-6. Locate the center of the beam on the wall and mark the ideal laser position.
7. Once you have marked the ideal laser position, turn the lamp off and set the
LAD continuously on (see "Choosing a Macro (MACR)" on page 5-8, and
choose the "LRON" menu option).
8. Look at the wall where the laser is projected to determine the current laser
position in relation to the mark you made on the wall for the ideal laser
position.
Caution: Do not stare into the laser beam or view it directly with
optical instruments.
6-6 Laser Aiming Device (LAD™) Operation Studio Spot
Lightly mark the center of the beam
2
on the wall along the ruler.
Measure 3.3 in (8.4 cm) for Studio Spot 250
4
fixtures, or 3.5 in. (8.9 cm) for Studio Color
250 fixtures above the center point of the
marks you made on the wall to mark where
the laser should shine.
®
250 / Studio Color
®
250 User Manual