Pan And Tilt; Position - High End Systems Studio Spot 250 User Manual

Table 3-1. Fixture Constructs and Channel Assignments
Fixture Type
Studio Color
250

Pan and Tilt

The Pan and Tilt constructs are available for both Studio Spot 250 and Studio Color
250 fixtures. Both fixtures offer 570° pan and 270° tilt motion. DMX channels 1 and 3
allow coarse positioning to approximately one degree of the desired pan and tilt
position. DMX channels 2 and 4 allow fine positioning to a fraction of a degree of the
desired pan and tilt position.
By default, the pan/tilt motion of Studio Spot 250 and Studio Color 250 fixtures is
controlled with MSpeed values. If you choose to control the Pan and Tilt constructs
with DMX controller crossfading, you must use the Control construct to set pan/tilt
MSpeed off (see "Control" on page 3-14).
Note: Optical encoders for pan and tilt instantly correct the fixture's position
if the fixture is jarred from its programmed position. If a physical
obstruction prevents the fixture from correcting its position, the fixture
will "time out" to prevent wear on the motors. If your fixture has timed
out, remove the obstruction and home the fixture to return it to normal
operation.
®
Studio Spot 250 / Studio Color
Construct
Pan Coarse
Pan Fine
Tilt Coarse
Tilt Fine
Color Function
Cyan
Magenta
Yellow
Beam Shaping
Focus
Shutter
Dim
MSpeed
Macro/LAD™
Control
®
250 User Manual
DMX Channel
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Operating the Fixture
3
3-3