Control; Table 3-13. Macro/Lad™ Settings; Table 3-14. Control Settings - High End Systems Studio Spot 250 User Manual

Macros are factory-programmed sequences which allow you to quickly program
complicated looks (such as a ballyhoo) in one scene. Each macro modifies a specific
set of constructs, while allowing user control of all other constructs in the scene. You
can also create an entire sequence by selecting the random macro which randomly
plays all pre-programmed macros. For more information on which constructs are
used in each macro, see "Appendix B Macros" on page B-1.
The fixture's optional Laser Aiming Device (LAD ) is also controlled with this
construct. Because the macros and the LAD share the same DMX channel, you
cannot use both a macro and the LAD at the same time. For more information on the
LAD, see "Chapter 6 Laser Aiming Device (LAD™) Operation" on page 6-1.
The macro/LAD settings are listed in Table 3-13.
Macro/LAD Setting
No Macros/LAD off
Macro 1 through 32
Random Macros (Variable)
LAD Off/No Macros
LAD Modulate (Variable)
LAD On

Control

The Control construct is available for both Studio Spot 250 and Studio Color 250
fixtures. This construct is controlled with DMX channel 18 for Studio Spot 250 fixtures
or DMX channel 15 for Studio Color 250 fixtures.
To access all control settings (except for Pan & Tilt MSpeed Off), first select a control
channel value, then set the Shutter channel to "0."
Among other functions, the Control construct allows you to remotely home the fixture
with a DMX controller.
Caution: You should home the fixture immediately if you notice that the
litho wheel has lost position (i.e. stuck between two litho
patterns). If the litho wheel is not correctly aligned in the
optical path, the wheel could be damaged.
The control settings are listed in Table 3-14.
Control Setting
Safe
Pan & Tilt MSpeed Off
3-14 Operating the Fixture
Table 3-13. Macro/LAD™ Settings
Sets the Macros and LAD off.
Plays the chosen Macro.
Plays all 32 Macros in random order at variable speeds.
Sets the Macros and LAD off.
Sets the LAD on to modulate at variable speeds.
Sets the LAD continuously on.

Table 3-14. Control Settings

Disables all Control settings for normal operation.
Sets Pan & Tilt MSpeed off.
Studio Spot
Description
Description
® ®
250 / Studio Color 250 User Manual