Identifying Display Panel Components; Linking The Fixtures; Figure 1-7. Front Panel Display - High End Systems Studio Spot 250 User Manual

Identifying Display Panel
Components
The front panel on Studio Spot 250 and Studio Color 250 fixtures has an
alphanumeric LED (Light Emitting Diode) display, five status LEDs, and four menu
navigation buttons (see Figure 1-7).
status
LEDs
Under normal circumstances, the alphanumeric display cycles between displaying the
fixture's software version ("Vxxx"), the fixture name (either "SPOT" for Studio Spot
250 fixtures or "COLR" for Studio Color 250 fixtures), and the fixture's address (either
"F xx" for fixture number or "Cxxx" for DMX start channel). However, if you are
experiencing problems with your fixture, the status LEDs and/or alphanumeric display
can also provide insight on where the problem is originating. For more information
on error messages, see "LED Display Error Messages" on page 8-1 or "Status LEDs" on
page 8-6.

Linking the Fixtures

To link one or more fixtures to a controller and/or to each other, you must obtain data
cabling. You can either purchase cabling from High End Systems (see "Optional
Accessories" on page intro-8) or construct your own cabling. If you choose to
construct your own cabling, it must adhere to the specifications listed in "Constructing
Cabling" below.
®
Studio Spot 250 / Studio Color
alphanumeric
LED display
Motor
Lamp
5V
Transmit
Receive
MENU

Figure 1-7. Front panel display.

®
250 User Manual
navigation
buttons
ENTER
Setup and Installation
1
1-7