Table of Contents
Advertisement
Setting an MSpeed Value (MSPD)
1. Using the <Up> and <Down> arrow buttons, scroll to the "MSPD"
construct and press the <Enter> button to select the MSpeed construct.
2. Using the <Up> and <Down> arrow buttons, scroll to the desired
MSpeed (in this example, "1.5") in decimal seconds and press the <Enter>
button to select the desired value.
In this example, the MSpeed value only affects the pan and tilt constructs,
because the pan and tilt values default to MSpeed time, and no other
constructs with MSpeed values were chosen.
Choosing a Macro (MACR)
1. Using the <Up> and <Down> arrow buttons, scroll to the "MACR"
construct and press the <Enter> button to select the macro construct.
2. Using the <Up> and <Down> arrow buttons, scroll to the desired macro
value (in this example, "MCOF") and press the <Enter> button to select
the desired value.
Note:
For a description of available macros, see "Appendix B Macros" on
page B-1.
Setting a Crossfade Value (XFAD)
1. Using the <Up> and <Down> arrow buttons, scroll to the "XFAD"
construct and press the <Enter> button to select the crossfade construct.
2. Using the <Up> and <Down> arrow buttons, scroll to the desired
crossfade value in increments of 0.1 or 1 (in this example, "1.5") and press
the <Enter> button to select the desired value.
Note:
The crossfade value will affect the DIM and FCUS constructs. Set the
unit of time used for crossfade (seconds, minutes, or hours) using the
TIME construct.
Setting a Delay Value (DLAY)
1. Using the <Up> and <Down> arrow buttons, scroll to the "DLAY"
construct and press the <Enter> button to select the delay construct.
2. Using the <Up> and <Down> arrow buttons, scroll to the desired delay
value in increments of 0.1 or 1 (in this example, "6.0") and press the
<Enter> button to select the desired value.
5-8
Preset Programming
®
Studio Spot
250 / Studio Color
®
250 User Manual
Advertisement
Table of Contents
Troubleshooting
