Replacing The Studio Color ® 250 Lens; Figure 7-21. The Three Lens Screws - High End Systems Studio Spot 250 User Manual

4. Remove the lens by pulling it straight up from the assembly.
5. Place the new lens in the assembly.
Note: Before installing the new lens, you may need to clean it by using a soft,
lint-free cotton cloth and a mild glass cleaning solution (containing no
ammonia).
6. Replace and tighten the three #2 Phillips-head lens screws that secure the lens
to the lens assembly.
7. Replace the bezel and engage the bezel latches.
Replacing the Studio Color
You will need:
• replacement lens
• #2 Phillips-head screwdriver
To replace the Studio Color 250 lens:
1. Electrically isolate the fixture. If the fixture has been operating, allow the
fixture to cool before handling.
2. Remove the bezel by unlatching the two bezel latches (see Figure 7-17).
®
Studio Spot 250 / Studio Color
remove the three lens screws and pull
the lens straight up from the assembly
lens

Figure 7-21. The three lens screws.

®
250 lens
®
250 User Manual General Maintenance
7
7-17