Figure 6-5. Remove The Bezel - High End Systems Studio Spot 250 User Manual

Note: The farther away the wall is, the more accurate your positioning will
be):
2. Remove the fixture's bezel cover by releasing the two bezel latches (see Figure
6-5).
release the two
bezel latches
3. Turn the lamp on (see "Turning the Lamp On or Off (LAMP)" on page 4-30).
4. Make sure that the light beam is round and not oval. If necessary, adjust the
pan and tilt construct values until the beam is round (see "Selecting a Pan
Value (PAN)" on page 5-4 and "Selecting a Tilt Value (TILT)" on page 5-4).
5. For Studio Spot 250 fixtures, adjust the focus until the edge of the light beam is
sharp (see "Selecting the Focus Value (FCUS)" on page 5-7).
6. Find the approximate center of the beam using either a tape measure or ruler,
and mark a spot 3.3 in. (for Studio Spot 250 fixtures) or 3.5 in. (for Studio
Color 250 fixtures) above the center of the beam where the laser should be
positioned (see Figure 6-6).
®
Studio Spot 250 / Studio Color

Figure 6-5. Remove the bezel.

®
250 User Manual Laser Aiming Device (LAD™) Operation
fixture with bezel removed
6
6-5