Figure 7-17. Remove The Fixture's Bezel - High End Systems Studio Spot 250 User Manual

9. Install the metal spring by inserting the spring into the wheel housing (over the
effect) and rotating the spring while pressing down.
When the spring is completely installed in the wheel, press the spring tip under
one of the four plastic tabs in the wheel housing (see Figure 7-16).
10. After replacing an effect, you may need to clean it by using a soft, lint-free
cotton cloth and a mild glass cleaning solution (containing no ammonia).
11. Replace the bezel and engage the two bezel latches unless there are other
dichroics, lithos, or effects you want to replace.
Replacing a Studio Color
This section shows how to replace the cyan, magenta, yellow, or beam shaping
(lenticular) wheel. You should replace the wheels if they are damaged or broken.
(See "Optional Accessories" on page intro-8 for ordering information.)
Warnings: Disconnect power before servicing.
Equipment surfaces may reach temperatures up to 130° C
(266° F). Allow the fixture to cool before handling.
You will need:
• C-clip tool
• #2 Phillips-head screwdriver
• 5/64 in. hex tool
• replacement wheel
To replace a Studio Color 250 wheel:
1. Remove the fixture's bezel by releasing the two bezel latches (see Figure 7-17).
release the
two bezel
latches
®
Studio Spot 250 / Studio Color

Figure 7-17. Remove the fixture's bezel.

®
250 User Manual
®
250 Wheel
fixture with bezel removed
General Maintenance
7
7-13