Setting The Lamp Warning Message (Lmpl); Mode Menu (Mode); Setting The Fixture Type (Type) - High End Systems Studio Spot 250 User Manual

Setting the Lamp Warning Message (LMPL)

Use this menu item to enable your fixture to display the warning message "LAMP LIFE
ERR" when the current lamp hours exceed 2,000. With this option enabled, after the
current lamp hours exceed 2,200 hours, the fixture will display the warning message
"LAMP OUT ERR." Once the lamp is extinguished, the fixture will no longer strike the
lamp until the current lamp is replaced and the current lamp hours are reset to zero
(see "Replacing the Lamp" on page 7-4 or "Resetting Lamp Hours (L/RS)" on page
4-39).
To enable the lamp warning message:
1. Press and hold the <Menu> button until "ADDR" appears on the LED
display.
2. Using the <Up> and <Down> arrow buttons, scroll to the "SET" menu
and press the <Enter> button to select the "SET" menu.
3. Using the <Up> and <Down> arrow buttons, scroll to the "LMPL" menu
and press the <Enter> button to select the "LMPL" menu.
4. Using the <Up> and <Down> arrow buttons, choose the "ON" option to
enable the lamp warning message, or the "OFF" option to disable the lamp
or
warning message. Press the <Enter> button to select the desired option.

Mode Menu (MODE)

The Mode menu allows you to set the fixture type to either Studio Spot 250 or Studio
Color 250, choose user A or user B settings, copy settings and presets to user A or user
B, and crossload software versions from one fixture to all other Studio Spot 250 or
Studio Color 250 fixtures on the link. The procedures below are listed in the order
they appear on the menu map (see Table 4-1 or Table 4-2).

Setting the Fixture Type (TYPE)

Use this menu item to change the fixture type to either Studio Spot 250 or Studio
Color 250. All fixtures are shipped from the factory set to the correct fixture type.
However, if the fixture's logic board is replaced, you must ensure the new board is set
to the correct fixture type.
To set the fixture type:
1. Press and hold the <Menu> button until "ADDR" appears on the LED
display.
®
Studio Spot 250 / Studio Color
®
250 User Manual Understanding the Menu System
4
4-25